Roco 42615 - ROCO LINE turntable with electric drive and control unit

Roco 42615 - ROCO LINE turntable with electric drive and control unit

Model details

Turntable with electric underfloor drive and control unit.
Suitable for all NEM-compliant two-wire direct current and three-wire alternating current railways. The platform length of 253 mm corresponds to a length of 22 meters in the original.

The minimum angle between two track exits is 9 degrees. The turntable comes with filler pieces with divisions of 1°, 3°, 6° and 9°. This means that any division between the track exits is possible in 1° increments from 9° upwards.
A maximum of 40 track exits can be used. The turntable comes with four track outlets for 2L =.
Other track outlets are available as accessories (42616, contents: four 2L = track outlets).
If the turntable is to be used on a center conductor AC railway, the specialist dealer will exchange the enclosed original pack of 2L = track outlets for a pack of 3L ~ track outlets (42617, contents: three 3L ~ track outlets) when purchasing the turntable.
The platform drive works with a supply voltage of 14 V ~. The driving voltage is supplied with direct or alternating current, depending on the system used. The turntable comes with a control unit with which the direction of rotation is preselected and the rotation is started. If the turntable switch is released, the turntable stops exactly at the next track outlet.

As with the original, two rotation speeds can be preselected on the ROCO model. The driving current is fed into the turntable. The driving voltage supply of the track exits can be assigned via the control unit. This prevents a locomotive that may have been parked at two opposite track exits from accidentally starting off.*

A 1 m five-pin cable (transformer - control unit) and a 2 m eight-pin cable (control unit - turntable) are included.

Installation dimensions:
Required installation opening: 280 mm;
Installation depth measured from the top edge of the table: 50 mm;
Outer diameter of the turntable without track exits: 307 mm;

Stage length: 253 mm, suitable for all locomotives up to a total wheelbase of 250 mm.

* When using the turntable in DCC mode (digital), a reversing loop module must be used.

 

Characteristics:

Manufacturer:	Roco
Item number:	42615
number of pieces:	1 piece
EAN:	9005033426156
Product Type:	Tracks
track:	H0
scale:	1:87
Age recommendation:	14 years and older
WEEE No.:	DE 67942834